28 Series


29 Series


The clip adapters are all designed to work with the FlashcatUSB xPort made by EmbeddedComputers, on that webpage is a list of the NAND and NOR flashes it supports.

It has a row of pin headers that you can use to change the pinout from supporting 28 Series NORs to 29 Series.

For 28 Series the pins will look like this:

29 28


For 29 Series the pins will look like this:

29 28


Using a jumper the power source can be switched between using power from the FlashcatUSB xPort to using power from an external power source. At the end of the board you can put pins which you can use to supply power from an external power source, there is also a footprint for a capacitor if you need it for your setup. The capacitor footprint is for a capacitor with 2mm lead spacing, something like this should work.

Sold Here

Revision #3
Created 11 May 2019 12:55:54 by Zeigren
Updated 26 October 2019 01:58:10 by Zeigren